Reversible adhesive bonding

Departments - Rearview

Michigan State University researchers develop bonding technologies to support the increased use of reinforced composites in cars.

Mahmood Haq, a Michigan State University civil and environmental engineering assistant professor, tests composite joining techniques.
(Photos courtesy of MSU Today)

As automakers increase their use of fiber-reinforced composites to lower vehicle weights and improve fuel economy, new joining methods will be required to assemble vehicle bodies. Composite materials are composed of fibers such as carbon, glass, and Kevlar held together using a polymer such as an epoxy. Mahmood Haq and his team at Michigan State University (MSU) Composite Vehicle Research Center are developing new ways to join composites with traditional materials to make cars lighter and stronger.

While manufacturing vehicles completely out of composites remains an expensive alternative, it is possible to replace many existing car parts with parts made of composites. When joining a composite to a metal, Haq said manufacturers want to avoid drilling holes in the composite.

“If you drill a hole with mechanical means, damage is introduced at the edges of the hole, and the layers that make up the composite separate,” says Haq, assistant professor of civil and environmental engineering at MSU. “You lose up to 60% of the capacity of the composite to carry load.”

Adhesive bonding can join parts effectively, but the technology has limitations.

“That, unfortunately, is a one-time cure. Once the adhesive cures, the joint can’t easily be undone,” Haq says.

So Haq and his team are working on advanced adhesives with special properties that allow them to be taken apart, repaired, or healed. These special properties are obtained by adding electrically conductive nanoparticles to the adhesives.

Adhesives can join composite materials to metals such as steel and aluminum, but once cured, the bond can be permanent.
(Photos courtesy of MSU Today)

“Millions of these nanoparticles are embedded in the adhesive,” Haq says. “By using what we call targeted heating we can bond them and reverse the bond and take them apart.”

When activated with the right kind of electromagnetic radiation, the nanoparticles begin to vibrate and heat the adhesive.

“Just the adhesive heats up, without having to heat up the entire structure,” Haq explains.

A key to making this joining technique practical is to be sure it can be integrated into today’s auto assembly line practices.

“We want joints that are easily and quickly produced,” he says. “We don’t want to have to totally re-tool the assembly lines. We don’t want to have to invent a new technology which disrupts current manufacturing practices.”

Researchers at Michigan State University test technologies that would make it easier to separate adhesively bonded components.
(Photos courtesy of MSU Today)

Much of the funding for Haq’s work is provided by the U.S. Department of Energy (DOE) and the American Chemistry Council.

MSU is a national leader in composite-material research and directs the light- and heavy-duty vehicle technology component of the Institute for Advanced Composites Manufacturing Innovation (IACMI), a 122-member consortium funded by a more than $70 million commitment throughout five years from the DOE.

Michigan State University Composite Vehicle Research Center